I agree with Steve Get yourself a smallish "angle grinder" electric
ones can be had for 30 bux or so. If you have a good sized air
compressor the air driven grinders are even better.
If you are only doing this a few times and you have no need for a
grinder (don't know how people get along without them tho) then a thin
cut off wheel for your skill saw will do the trick nicely. 73 bob de w9ge
K7LXC@aol.com wrote:
>
>
>
> A better option is to use a 4.5" hand-grinder. I couldn't do any tower
>work without one. Get the thinnest cutting blades and they'll cut thru EHS in
>a couple of seconds. Obviously all safety precautions should be used.
>
> I used to use the 7" aggregate cutting blade on my Skil saw but it was
>pretty cumbersome. The little hand-grinder is the only way to go!
>
>Cheers,
>Steve K7LXC
>TOWER TECH
>
>
>
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|