Towertalk
[Top] [All Lists]

Re: [TowerTalk] upgrading from a G5RV

To: K4SAV <RadioIR@charter.net>
Subject: Re: [TowerTalk] upgrading from a G5RV
From: David Gilbert <xdavid@cis-broadband.com>
Date: Tue, 19 Aug 2008 20:32:00 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Something looks pretty out of whack with those numbers.   According to 
TLW, you'd need an SWR around 150:1 to get 6.5 db loss from 30 feet of 
RG-213 at 14 MHz.

Dave   AB7E


K4SAV wrote:
> A quick check with EZNEC shows the following loss in the 30 feet of 
> RG213.  The antenna was placed at 40 feet.
>
> 3.5 MHz    2.17 dB
> 7 MHz       1.95 dB
> 10.1 MHz  4.42 dB
> 14 MHz     6.5 dB
> 18.1 MHz  2.28 dB
> 21 MHz      3.1 dB
> 24.9 MHz   4.35 dB
> 28 MHz      3.12 dB
>
>
> I didn't try to find a better solution, but different lengths of 450 ohm 
> line will produce a different set of answers and some lengths will 
> probably produce a set of numbers that is better than the one above.
>
> Jerry, K4SAV
>
> KI9A@aol.com wrote:
>
>   
>> Gang-
>>
>> After some serious tree trimming, I now have room to fit a full sized wire  
>> antenna where my G5RV is right now. I am thinking about a 135' open wire fed 
>>  
>> dipole, as multi bands are needed. 
>>
>> Question is this- there is now way I can get 450 ohm feedline into the  
>> shack.  The best I can do is about 30' of RG213, then the rest 450 ohm (  
>> maybe 
>> 90').  Is this going to be a waste of my time, or is it worth it? I'd  
>> obviously 
>> use a balun to change over to 50 ohm feedline.
>>
>> 73- Chuck KI9A
>>
>>
>>  
>>
>>     
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>   
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>