If that error is reproducible, I would certainly send it to W7EL.
Jerry
Steve Hunt wrote:
> Jerry,
>
> Thanks for the suggestion - I certainly hadn't across that particular
> configuration option.
>
> But sad to say it has made no difference: 10%, 1% 0.001% I still get the
> same gross error!
>
> Steve G3TXQ
>
> K4SAV wrote:
>
>> Steve
>>
>> I have also seen cases where EZNEC will not repeat the results of a
>> calculation after reopening a file and re-running it. It's sometimes
>> frusterating when you are preparing some data, need one more piece of
>> data, rerun the file and everything changes. I always thought it was
>> because EZNEC was changing the data it was using for the ground model.
>> It stores that data and doesn't necessarily recalculate it every time,
>> and I thought it was just making a different decision about which
>> ground-data file to use. Usually when it does this, the answer is only
>> different by tenths of a db, however in your case, seems it was making a
>> really gross error. Check your setting for "ground file tolerance".
>>
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|