I bought some of these, but the individual wires are
sealed, rather than the whole cable. This means the
the outer diameter of the individual wires must be
just right. Note that this is the diameter of the
insulation not the wire gauge. In rotor cable, typically
there are 2 fat wires and 6 skinny wires. I decided
not to use these connectors as being too much trouble.
Rick N6RK
Gary "Joe" Mayfield wrote:
> This is what you want
>
> http://tinyurl.com/ne3sct
>
>
> Standard disclaimer.
>
> 73,
> Joe kk0sd
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of RICHARD SOLOMON
> Sent: Thursday, August 06, 2009 6:01 PM
> To: TowerTalk
> Subject: [TowerTalk] Rotator Waterproof Connectors
>
>
> What would folks recommend for a "quick-disconnect" connector for the
>
> Rotor at the Tower Top end ?
>
>
>
> 73, Dick, W1KSZ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|