Towertalk
[Top] [All Lists]

Re: [TowerTalk] OR2800 pulse switch replacement

To: Dan <n5ar@air-pipe.com>
Subject: Re: [TowerTalk] OR2800 pulse switch replacement
From: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>
Date: Fri, 23 Oct 2009 22:51:48 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>

Dan wrote:
> I have one of these rotators with a faulty pulse reed switch and am 
> curious how difficult it is to replace it. 
I wonder if these are the same as the ones used in the old C-band dish 
positioners?

73

Roger (K8RI)
> Has anyone on the list done 
> that? I understand the switches are available from M2. I would like to 
> avoid the shipping of this heavy brute.
>   I believe the switch is near the bottom of the unit and would 
> apparently require removing most of the gears. Do they come out piece by 
> piece or is it possible to remove them as one or several assemblies?
>   During a recent conversation with Wyatt he indicated they were  
> looking into the possibility of providing an access plate to allow 
> replacement of the switch. As I recall he indicated they were studying 
> whether the present casting could be machined for the mod or a new 
> casting would be needed.
>   I have been using 2 of the OR2800's for about 8 years. During that 
> time I have had 2 pulse switch failures, both during electrical storms.
>
> 73, Dan, N5AR
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>   
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>