Towertalk
[Top] [All Lists]

Re: [TowerTalk] wall plate jack for the 8 wire rotor cable

To: "Kurt Cathcart, KR2C" <Kurt@KuhlRoad.Net>
Subject: Re: [TowerTalk] wall plate jack for the 8 wire rotor cable
From: "Joe Giacobello, K2XX" <k2xx@swva.net>
Reply-to: k2xx@swva.net
Date: Wed, 03 Nov 2010 12:43:05 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
  Kurt, I use 8-pin Cinch (Jones?) jacks and plugs between my rotors and 
the wall plate (SPG panel).  They allow quick disconnect in the evnt of 
a lightning storm and have served me well over the years.

73, Joe
K2XX

On 11/3/2010 12:27 PM, Kurt Cathcart, KR2C wrote:
> Currently I have my Hy-gain rotor cable coming through a hole in a
> stainless steel wall plate with  a grommet.  I have wound up on the
> floor a bunch of excess cable before it goes to the control box.  Does
> anybody make a good connector that I could mount in the wall plate so
> that I can use a shorter jumper cable from the wall to the control box?
> this way I wouldn't have to worry too much if I should re-arrange the shack.
>
> -Kurt
> KR2C
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>