I bought a crimping tool at Dayton with two dies, but the openings in
the dies are identified only by dimensions, not by the connector they
are to be used on. I've tried Googling without success, but suspect
there must be a table somewhere that I can use for reference - any ideas?
--
73, Pete N4ZR
The World Contest Station Database, updated daily at www.conteststations.com
The Reverse Beacon Network at http://reversebeacon.net, blog at
reversebeacon.blogspot.com,
spots at telnet.reversebeacon.net, port 7000
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|