Towertalk
[Top] [All Lists]

Re: [TowerTalk] Dipole fed with balanced line?

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Dipole fed with balanced line?
From: Jim Lux <jimlux@earthlink.net>
Date: Tue, 17 Jan 2012 11:00:14 -0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 1/17/12 10:31 AM, Ken wrote:
>
> On Jan 17, 2012, at 10:52 AM, Paul Christensen wrote:
>
>> With top loading for verticals, or end-loading for dipoles, super
>> high efficiency can be maintained.  I would start by reading
>> Sevick's work as a general analysis of shortened antennas, and also
>> study how and why a radiator's feedpoint Z, I, and E changes with
>> radiator length.
>
>
> Paul,
>
> THERE I agree with you because the high current portion (e.g. center
> portion of a dipole, or the "effective" quarter wave portion of a
> vertical) is used as a radiator.  End loading works well because the
> high current section of a half wave is still the radiator), but just
> using the ends of a dipole (e.g. center loading,etc.) is not nearly
> as effective.
>
> Shortening a half wave dipole, without end loading, significantly
> reduces it's efficiency.

Not exactly. What end loading does is make the feedpoint impedance 
closer to your desired resistive value.

Think of this... a 1/4 wavelength long dipole is going to look very much 
like a capacitor.  If you were matching at the feed, you'd add an 
inductor.  Now, say I wanted to avoid an inductor, and instead, what I 
used was a capacitor at the end of 1/4wavelength line (so the line 
transforms the C into L).  That would work about the same (ignoring losses).

Well, I could just as easily hang that capacitor at the end of the 
antenna element, which just so happens to be 1/4 wavelength long.

There's a whole lot of handwaving and there's some technically incorrect 
stuff I just did (end loading isn't really a C at the end of a 1/4 wave 
line).. but the idea is sound... leaving aside the change in current 
distribution along the radiator, how you get the feedpoint Z to be 
reasonable can be done a lot of ways.

You can also make a folded dipole, which transforms a 75 ohm dipole to a 
300 ohm one.  Basically, the two wires in the dipole form a transformer, 
and one that hopefully has cost, loss and structural benefits over an 
alternative scheme of a transformer with 1:2 turns ratio at the feedpoint.

>
> A 70' dipole used on 80m without end loading is much less efficient
> of a radiator than the same antenna with end loading.   And the
> simplest way to end load such an antenna is to add about 30' of wire
> on each end ;-)
>
> Ken  WA8JXM _______________________________________________
>
>
>
> _______________________________________________ TowerTalk mailing
> list TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>