First try a big drill, like a Milwaukee right angle VSR model.
Rick N6RK
On 2/27/2012 12:55 PM, Wayne Crawford wrote:
> Greetings!
>
> Has anybody here done a retrofit motor drive to run a TX-472 up. I did a
> modification on the hand winch with a coupling nut on both the tower and
> raising fixtures. Using a drill I am able to get the raising fixture to lift
> the tower up quite nicely. However the tower itself just weighs too much for
> the same drill to run the tower up. The drill won't budge it. I was thinking
> of using an impact wrench but am not certain if this would be appropriate.
>
> thoughts!
>
> Thanks& 73
>
> Wayne C.
>
>
>
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|