On 03/14/12 04:46 pm, Tony wrote:
> I called Fulton and asked if the bolt pattern on their K2550 winch was
> the same as the K1550. The tech said it was close, but not a match. I
> know that more than one member of this reflector has replaced the 1550
> with the 2550 on a U.S. Tower TX80 raising fixture without modifying
> the mounting plates on either the winch or the fixture so the only thing
> I can think of is that Fulton may have modified the bolt slots on the
> winch at one time. Any ideas?
The slotted holes on the K2550 I bought a few years back lined up just
fine with the holes on the TRX80. The holes may not be the same on the
two winches, but the slots may be long enough to make for an easy
changeover.
73
Alan NV8A
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|