Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rotator cage design

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Rotator cage design
From: Michael Tope <W4EF@dellroy.com>
Date: Fri, 15 Jun 2012 08:13:34 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I think the cage pictured on the G0HWC website is the same cage sold in 
the U.K. by Tennamast

http://stores.ebay.com/Tennamast?_trksid=p4340.l2563

Also, Greg Ordy W8WWV has a homebrew cage on his website:

http://www.seed-solutions.com/gregordy/Amateur%20Radio/Experimentation/RotatorCage.htm

73, Mike W4EF..............



On 6/14/2012 4:52 AM, john@kk9a.com wrote:
> I agree with Kurt, adding a bearing plate is the best approach for your
> tower. Here is one example: http://www.g0hwc.com/latest_projects.html
>
> GL,
> John KK9A
>
>
> from [Rick Kiessig]   [Permanent Link][Original]
> To:   <towertalk@contesting.com>
> Subject: [TowerTalk] Rotator cage design
> Date:  Thu, 14 Jun 2012 18:02:12 +1200
>
>
> I understand that rotators are not designed to handle lateral loads, and
> that I should therefore have the rotator on one shelf, then a second shelf
> above that with a radial support bearing on it, to handle the lateral
> loads. The most likely antenna at the moment (still a moving target)
> weighs 29kg, with a 7.2 sq ft wind load and a 6m turning radius. Kurt K7NV
> suggested welding two plates on the side of my pole/tower, at the top, a
> few feet apart. Does anyone know of existing designs/drawings for that
> kind of
> thing?
>
> 73, Rick ZL2HAM


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>