On 7/19/2013 7:59 AM, Hector Garcia XE2K wrote:
There is no problem to run the LMR-600 , if you are sure you have the 75 ohms version
you can "adjust" for 50 ohms
There is a simple, but tried and true method for using 75 ohm cable to
feed a 50 ohm load. Simply make the 75 ohm line an EXACT multiple of
half-wavelengths at the operating frequency. This works because the
impedance transformation that happens in any transmission line comes
back to where it started every half-wavelength.
Getting the length right is also easy -- put a connector on one end and
measure the impedance using any antenna analyzer with the far end
shorted. When it's an exact multiple, it will measure as a short. To
calculate the length, use the velocity factor of the coax and cut it a
little long, then trim until it's right.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|