Towertalk
[Top] [All Lists]

Re: [TowerTalk] Cadwelding ground rods

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Cadwelding ground rods
From: Jim W7RY <w7ry@centurytel.net>
Reply-to: w7ry@centurytel.net
Date: Wed, 01 Jan 2014 09:32:51 -0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Bend the top vertical with a piece of pipe.

Not sure if you can get the weld material level in the mold or not. Best if the mold can be level or you will end up with a bad weld.

73
Jim W7RY

On 1/1/2014 9:22 AM, Mike Fahmie wrote:
How close to vertical must Cadweld One Shots be?  I'd like to drive some ground 
rods diagonally into the sides of my tower foundation hole but am concerned 
that the One Shots might not function properly on a non-vertical rod.


-Mike-
WA6ZTY
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>