That's ceramic and death to metal saw blades.
It takes a good, thin, abrasive blade, or better yet a diamond blade.
Then you need to lap the mating surfaces flat enough that they want to
stick to each other.
I made my other post earlier, but lost the internet so it's way out of
sequence.
Don't know if the problem is the router or this computer. It's a
gigabit router and all but one connection are showing 100Mbs instead of
1000Mbs. At any rate it's so slow it's dropping connections.
73
Roger (K8RI)
On 2/10/2015 2:14 AM, Ron W8RJL wrote:
Last time I tried to saw a core it wiper the teeth right off a hack
saw blade. Maybe it was a bad blade? Tried another, then gave up.
Ron W8RJL
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|