I use a small general-purpose automotive scissors-jack on my TX489MDPL.
Randy
KZ4RV
On 2/23/2015 6:35 PM, jdlambrightatty@gmail.com wrote:
I have a motorized raising fixture for my US Tower HDX-589MDPL , and just last
week I successfully raised it to the vertical position for the first time.
Everything went very smoothly and effortlessly with the 1 HP motor and 50:1
ratio Hub City worm gear drive. Raising takes about 4 minutes. I haven't
installed my antennas, rotator etc. yet.
My question is what is the best way to get the tower moving from the vertical
position when I want to lower it to horizontal again? It weighs about 2,500 lbs
and is sitting very plumb on its base. Of course once it's leaned a bit, the
motorized fixture will easily lower it. There's no way you can just push it
even with some slack in the aircraft cable.
I suspect someone on the list has a simple solution.
J D Lambright
Montgomery County Attorney
936-539-7930
Sent from my iPhone
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
I am using the free version of SPAMfighter.
SPAMfighter has removed 2174 of my spam emails to date.
Get the free SPAMfighter here: http://www.spamfighter.com/len
Do you have a slow PC? Try a Free scan
http://www.spamfighter.com/SLOW-PCfighter?cid=sigen
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|