Towertalk
[Top] [All Lists]

Re: [TowerTalk] Unequal Radial Currents

To: Dennis W0JX <w0jx@yahoo.com>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Unequal Radial Currents
From: "Richard (Rick) Karlquist" <richard@karlquist.com>
Date: Sat, 29 Aug 2020 19:16:28 -0700
List-post: <mailto:towertalk@contesting.com>


On 8/29/2020 5:44 PM, Dennis W0JX via TowerTalk wrote:
Unequal currents in 1/4 wave radials is to be expected primarily due to three 
factors: 1.) varying quality of the ground under each radial; 2.) the effect of 
close by objects such as buildings and other towers; and 3.) the variation in 
the length of the radial wires depending on type of wire, insulation, and 
construction methods. Effect on the actual radiation pattern depends, of 
course, on the severity of the current variation and the number of radials 
utilized.
Dick Weber, K5IU, wrote a very informative article in the late 90's which was 
published in Communications Quarterly. He argued that 1/4 wave long radials 
were the poorest length on could use. He strongly recommended radial lengths of 
either 60-70 degrees (shortened) or 120 degrees long. These radials are tied 
together at a common point and fed either through a coil or a capacitor.
W5UN had a very successful 4 square for 160 meters which used four, 96 foot 
long radials fed through a common coil. The radials were about 15 feet off the 
ground.
Here at W0JX, I have four, 48 foot radials on my elevated 80 meter ground 
plane. The four radials come to a common point below the radiator and are tied 
to the coax shield through an inductor of approximately 3.3 uh. A big advantage 
of this arrangement is that I can resonate the antenna system by moving the tap 
on the radial loading coil. After many years of using full-sized radials, my on 
the air results tell me that the shortened radials are working better than the 
full size radials did.
73 Dennis W0JXMilan OH


I'm not following the logic here.  If various radials have
unequal impedances, I don't see now tying them in parallel
though a coil or capacitor with magically make them have
equal currents.  Did Dick actually compare the currents in
the various configurations as built?  All I see are anecdotes,
not AB comparisons or measurements.

Now if someone told me to use shortened or lengthened radials
and put individual coils or capacitors in series with each radial, then
I might believe the currents would be forced into equality.
Are you sure you got the story straight about Dick's article?
(I don't have access to it).

73
Rick N6RK
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>