Towertalk
[Top] [All Lists]

Re: [TowerTalk] Thrust bearing re-grease

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Thrust bearing re-grease
From: Eugene Jensen <eugenejensen@nyc.rr.com>
Date: Tue, 04 Nov 2008 20:32:08 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Take a pick and check to see if there is a hole into the bearning itself. I 
have seen more than once a sealed bearing and no place for the grease to go. 
That might be the reason there was no zerk on it and it was a plug in it 
place. You will hit the race of the bearing shell. Remenber this will turn 
so slow that many different designs have been used. I have a Telex here that 
the thrust is a brass plate that have 2 grooves in it. Worked well well for 
twenty years on a 38 ft crankup tower. 73 Gene K2QWD


----- Original Message ----- 
From: "Drax Felton" <draxfelton@gmail.com>
To: "'Wayne Kline'" <w3ea@hotmail.com>; <towertalk@contesting.com>
Sent: Thursday, October 30, 2008 10:56 PM
Subject: Re: [TowerTalk] Thrust bearing re-grease


> This one is labeled as  "Falnir LCJ   1-15/16"    New Britain, Conn."
>
>
>
> I need to locate a ring to clamp the mast to the thrust bearing. The
> original is missing.
>
> Any ideas on where to find one?
>
>
>
> As far as re-greasing it.  I figured it out.  While taking a closer
> inspection I found it has screw tap in it for a grease fitting.  I'm not
> going to need to pull it.
>
>
>
>
>
>
>
> Drax
>
> KB3X
>
>
>
>
>
>
>
> From: Wayne Kline [mailto:w3ea@hotmail.com]
> Sent: Thursday, October 30, 2008 11:21 PM
> To: draxfelton@gmail.com; towertalk@contesting.com
> Subject: RE: [TowerTalk] Thrust bearing re-grease
>
>
>
> Drax...
> I need you to be more specific ,, Is it a Rohn ? ( Rohn thrust bearing 
> have
> ROHN cast on the flange and TB2 or TB3 and three  3/8 locking bolts )
>
>
> Wayne W3EA
>
>> Date: Thu, 30 Oct 2008 23:10:18 -0400
>> From: draxfelton@gmail.com
>> To: towertalk@contesting.com
>> Subject: [TowerTalk] Thrust bearing re-grease
>>
>> Could someone recommend what puller tool I would need to beg, borrow,
>> or buy to pull a thrust bearing apart with to re-pack it with grease?
>> I'm not that familiar with bearings or whether the tool used for
>> automotive bearings that a mechanic might have would work or not. I'm
>> talking about a thrust bearing that in all is maybe 6 inches wide.
>>
>> Drax
>> KB3X
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>