In a message dated 5/18/2010 2:26:25 A.M. Pacific Daylight Time,
towertalk-request@contesting.com writes:
> 1. Remove the allen screw
2. remove the ball bearings one by one through the hole left by the screw.
3. Now the bearing halves will come apart.
4. clean the races and ball bearings with brake clean.
5. Apply grease to the races.
6. reassemble the halves.
7. reinsert the ball bearings.
8. Reinsert the allen screw.
have a beer, all done.
> You have to disassemble it. The clunking is the dried out grease in
the
races and has to be cleaned out.
Wrong. DO NOT lubricate a TB-3 bearing. See my previous post.
Cheers,
Steve K7LXC
TOWER TECH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|