Did you think about asking the manufacturer?
73, Pete N4ZR
At 09:21 PM 3/29/2008, Daron Wilson wrote:
> >Forgive my bluntness...but...
>
> >Maybe you should hire an engineer to consult and provide guidance on this
> >subject with you.
>
> >It's obvious that no one's reply to your query here is what you are looking
> >for.
>
> >73,
> >Dale, kg5u
> >(15 years of skirts on two Rohn 45G towers (30miles from the Gulf of
>Mexico)
> >and not a clang to be heard or rusting to be seen.)
>
>
>Thanks...all I was asking was for how these are supposed to be installed. I
>don't want to install plywood/chickenwire/lexan or whatever, simply, I was
>asking what is the proper installation technique for this product?
>Now...assuming you have them installed properly, I'm asking, how? Did you
>just hold them tight to the tower and install the self drilling screws
>provided from Rohn thus screwing all three sections together? Assuming you
>did, did you electrically bond them to the tower ground or are they
>'floating'? If they don't make any noise, you must have installed them in a
>manner so they are pinched tight up against the tower? It really should be
>a simple question.
>
>Thanks,
>
>Daron N7HQR
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|