At 03:14 PM 12/4/2006, Don Havlicek wrote:
>Use a piece of flat aluminum plate, bending it to the correct angle
>and put screws through the plate into the side of the plastic relay box.
>Then mount the aluminum plate to a tower leg with a U-bolt.
It's actually going inside another box.
But, it's the "fabricate bracket" thing that I thought I might avoid,
if there were a suitable replacement box. If there were a plastic
(or metal) box that matched the right dimensions, I can just drill
that box, screw it to the side of the enclosure, and be done with it.
You've given me a good idea, though.. I can probably use an off the
shelf angle bracket (which I have lots of) and attach it to where the
MFJ mast bracket normally goes.
Jim
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|