You can try hooking the pipe up to a water hose. The flowing water will
soften and move the soil away as you push the pipe down into the ground.. I
have read of this being done.
Mark N1UK
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
----- Original Message -----
From: "Dan Bookwalter" <n8dcj@yahoo.com>
To: <towertalk@contesting.com>
Sent: Wednesday, 25 May, 2011 8:28 AM
Subject: [TowerTalk] Copper Pipe Ground Rods - Driving them in - How ?
> Ok , I have most of my ground system planned out , my plan is to use
> copper pipe
> (type "L") and silver solder flashing to them from the tower etc... my
> issue is
> how in the world do you guys drive copper pipe into the ground , I have
> access
> to a 1/2" hammer drill , but , the pipe is too large for that , I am going
> to
> check into a ground rod bit for it , but , I am still not so sure if that
> will
> work.
>
> Suggestions ??
>
> Dan N8DCJ
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|