Yes for sure. Even a small drilled divot or a little flat area filed on the
mast for the screw to land on will give more resistance to twisting.
John NA6L
-----Original Message-----
From: john <john@kk9a.com>
To: TOWERTALK <TOWERTALK@contesting.com>
Sent: Sat, Apr 7, 2012 7:32 am
Subject: Re: [TowerTalk] HAM IV rotor / mast slipping / Slipp-Nott
If you drilled into the mast this method would even work better.
To:towertalk@contesting.com
Subject:Re: [TowerTalk] HAM IV rotor / mast slipping / Slipp-Nott
From:dotravel@aol.com
Date:Fri, 6 Apr 2012 23:27:51 -0400 (EDT)
One simple (and easy/cheap) thing to try:
Drill and tap the clamp plate for 4 additional 3/8" pinch bolts/screws
and
use the hardened type with the concave tips. Space the bolts in two rows
located 1/3 of the way in from the from each side edge and about 1/3 of the
way
down from the top edge and 1/3 of the way above the bottom edge. If the
clamp
plate is too thin for enough threads add a surface welded nut to the outsied
of
the plate.
Unless you mast is super hard material, having 5 pinch screws should go a
long
way to keeping the mast from rotating.
John NA6L
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|