My 2c, again
In terms of number installed I think most rotators have angular contact
ball bearings. HyGain, Yaesu, & prop pitch all are angular bearings,
which are the only ball bearings designed for both radial and thrust
loads. They should to be loaded to keep the balls in correct position
in the grooves. (but die cast aluminum races and steel balls are not
much of a bearing so nobody notices).
K7NV advises the entire thrust load be on the prop pitch motor.
The pipe sleeve on my HDX589 is the simplest radial bearing and has the
further advantage that the mast can't tilt when the mast is raised to
service the rotator. So if the vertical load is less than the spec (eg
440# for a Yaesu G1000), use a sleeve radial bearing of plastic and
never ever have to lube it or replace a worn out "thrust bearing" or one
seized up from rust.
Orion is an exception that uses a real thrust bearing and deep groove
ball bearing combo which is spec'd for thrust loads up to 1800#. Will
your tower handle that? SPID rotators also use oversize deep groove
bearings so preload isn't needed. So each rotator design has different
properties.
The only add-on sold as a "thrust bearing" that I think has competent
engineering is the angular contact one from DX Engineering.
Grant KZ1W
On 12/27/2019 04:38, David Gilbert wrote:
Another guy just said the same thing you did, and I'm not sure that is
universally a good idea. I expect Steve to eventually weigh in here
with more authority on the subject, but from what I understand some
rotators WANT to have some vertical weight on them to keep the bearings
properly aligned. Free floating bearings aren't always a good idea.
Dave AB7E
On 12/26/2019 5:46 PM, W3YY wrote:
John -
Next time install two bearings that provide both lateral and thrust
support.
And then install the mast so there is no weight on the rotor. Then
you can
easily remove and replace the rotor.
73, Bob - W3YY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|