Towertalk
[Top] [All Lists]

Re: [TowerTalk] Vertical Antenna Question

To: Howard Hoyt <hhoyt@mebtel.net>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Vertical Antenna Question
From: M?ximo EA1DDO_HK1H <ea1ddo@hotmail.com>
Date: Thu, 9 Apr 2020 18:57:09 +0000
List-post: <mailto:towertalk@contesting.com>
>one of the main reasons broadcast facilities do not need CM chokes at the 
>antenna feedpoints is: they are tuned to one frequency only so the match can 
>be >optimized to the point where there is little to no CM current.  

Rob, How they use to do that optimization?

Thanks

73, Maximo


-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Howard 
Hoyt
Sent: jueves, 9 de abril de 2020 19:40
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Vertical Antenna Question

Rob,

I've been a broadcast engineer for 40 years, and of course radials are 
mandatory with a vertical radiator, but one of the main reasons broadcast 
facilities do not need CM chokes at the antenna feedpoints is: they are tuned 
to one frequency only so the match can be optimized to the point where there is 
little to no CM current.  Some transmitter manufacturers like Nautel specify a 
CM choke at the transmitter itself, but this is largely to provide an 
inductance to delay a potential lightning surge on the feedline itself until 
the stout grounding system found at commercial transmission facilities drains 
most of the charge.

Amateurs are frequency agile and a perfect match is seldom found on a single 
antenna on all frequencies used.  In this situation a CM choke forces radiation 
by the antenna instead of the feedline and the ham will see the true antenna 
system match with the feedline out of the equation.  Many hams think their 
antenna is a good match over a wide range of frequencies when the is feedline 
radiating until they install a good CM choke at the feedpoint...then reality 
can rear it's ugly head.

Cheers!
Howie / WA4PSC


>>Not if you use enough radials.  I don't think I've ever seen ferrite
>>cores out on heliax at AM broadcast towers.  If you use enough
>>radials, the return current will be so divided down that the current
>>on the outside of the feedline (burying it helps but isn't necessary)
>>will be negligible.  If you have to use ferrite cores to keep RF off
>>your feedline exterior, you don't have enough radials down.

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>