Towertalk
[Top] [All Lists]

Re: [TowerTalk] Mounting Yagi on the side of the Trylon tower.

To: Alex Filippov <wk1ontario@gmail.com>
Subject: Re: [TowerTalk] Mounting Yagi on the side of the Trylon tower.
From: Mpridesti via TowerTalk <towertalk@contesting.com>
Reply-to: Mpridesti <mpridesti@yahoo.com>
Date: Mon, 25 Mar 2024 21:35:40 -0400
List-post: <mailto:towertalk@contesting.com>
We’ll discuss tomorrow 

Check out vctowers.net

Regards,

Mark, K1RX


> On Mar 25, 2024, at 8:30 PM, Alex Filippov <wk1ontario@gmail.com> wrote:
> 
> I am looking for antenna and installation advice.
> 
> I am looking to install a tri-bander 10-15-20 on the side of the
> self-supporting 80 ft Trylon tower at around 35 ft above ground level to
> stack with the tri-bander at the top of the tower. I really would like this
> antenna to rotate maximally around the tower. Obviously, there is a limit
> to how much it can be turned. The distance between the center ( driven?)
> element of the tri-bander and the next element should be maximally possible
> to accommodate the max rotating angle. Also is the length of the arm on
> which the antenna will be installed.
> 
> I am looking for practical advice on the best suitable commercially
> available tri-banders for such application and any advice on the
> installation. It looks like it will need two horizontal arms, rotator
> plate(s)
> 
> I'm sure this has been done many times before, so if you know where to look
> for advice to avoid the errors of the first time tinkerer, that would be
> greatly appreciated.
> 
> Thank you,
> 
> Alex, WK1O
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>