Hank, W6SX is having trbl with his roller inductor:
"I recently returned to the air after an eight year absence. The
roller inductors in my Nye MB-V-A and my Ten Tec 4229 antenna tuners
have corroded and are intermittent. I have squirted contact cleaner
on the coils and rollers and run the rollers back and forth with no
improvement. Does anyone have any suggestions?"
Hank, I've found that simply squirting them doesn't do it. I spray the contact
cleaner on a cloth and then hold the cloth against the inductor while rotating
it back and forth. You won't believe the crud that comes off. I also clean the
shaft that the little roller contact rides on and then apply a VERY SMALL
amount of commercial no-alox type stuff on the shaft and then run the inductor
from one end to the other several times to make sure the shaft is covered.
Good luck with your tuner.
73
K9WN Jake
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|