Hello
I have an old AIM4170 and I want to run it in a new computer
I open the software and it told me that I need to calibrate
I did standard calibration, when I connect the short circuit connector a
message that say
Cal Load Warning
the load impedance is aproximately 20152.979 instead of 0 ohms. Do you want
to continue? I said yes and it go.
Then I attach the open circuit
Cal Warning
there seems to be a long stub on the RF connector. The cfalibration may not
be accurate around 2 Mhz, Do you wan to continue? I said yes and it go
Then I attach the standard resistor (200 ohms) and another message
Cal Load Warning
The load impedance is aproximately 16659.519 instead of 200 ohms. Do you
want to continue?
I continue
Another message: make sure the loads were correct for the short and open
cal procedure
After that: do you want to save the new data. I save it
Calibration is complete NOTE Zref=50
But when I want to scan an antenna the results are vert strange
Seems something wrong when calibration, right?
--
73,
Jorge
CX6VM/CW5W
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|