Ted-
I just tried it on a model of a 20M 2 element beam in EZNEC.
Adjusting the length of the reflector from 218" to 225" did not affect
the frequency of lowest SWR, but it did, in my case, cause the
feedpoint impedance to move closer to 50 ohms than it started
at. ( I might take that antenna down and adjust it!)
I did not check the other parameters of the beam such as
F/B ratio, SWR bandwidth, gain, gain bandwidth, etc. I know from experience
that all of those will be affected, though.
Hope this helps.
73
Tom K0SN
On Sun, Oct 29, 2017 at 1:24 PM, <k2qmf@juno.com> wrote:
> Hello All,
>
> For a 2 element yagi
> Will increasing the design length of the reflector
> cause the resonant frequency to:
>
> 1 - Go Up?
>
> 2 - Go Down?
>
> 3 - Stay the Same?
>
> Thanks in advance for any input..
>
> 73,
> Ted K2QMF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|