Be careful of the template. I have one that is off about what you see (as I
remember). I don't remember which rotator it was for but it came from the
back of the rotator manual.
73
Gary K4FMX
> -----Original Message-----
> From: TowerTalk [mailto:towertalk-bounces@contesting.com] On
> Behalf Of James Wolf
> Sent: Saturday, July 11, 2020 9:07 PM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Ham II rotor mounting holes
>
> I have a Tailtwister that needs to come down for limit switch
> and indicator problems. I have a Ham II rotor that I am
> going to temporary put in its place.
>
> Will the Ham II rotor's four mounting bolts fit in the same
> four holes that are drilled for the Tailtwister?
>
> The Ham II's holes are 3 inches apart, but the template I
> have for the Tailtwister measures about 2.9 inches. Is the
> template distorted?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|