The old-time cabinet makers used beeswax as a "polish" type coating for the
interiors of drawers, cabinets, wardrobes etc. Turpentine is used to dissolve
the beeswax. The mixture is rubbed on the bare wood and buffed with a soft
cloth. Leaves a soft satin finish and for most people a pleasant smell. Just
add the turps a little at a time to the wax in a lidded container. Break up the
wax into chunks to increase the surface area and speed the process. Every hour
or two poke at the mix and stir it up a bit. Takes a few hours for the magic to
happen. Control the viscosity by the amount of turps you add. Stores forever in
a container with a tight-fitting lid. No heat, and the associated risk,
required. Excellent lube for wood screws as well. Unlike soap it doesn't
attract moisture.
73
Patrick, W7TMT
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Rob Atkinson
Sent: Saturday, September 23, 2023 03:30
To: towertalk <towertalk@contesting.com>
Subject: Re: [TowerTalk] MA 550 Beeswax?
I got beeswax a number of years ago on-line that was in the form of small
pellets. I softened it up by putting some of the pellets in a metal coffee can
along with some lamp oil and heating over a stove burner. It doesn't take much
heat and you have to watch it for safety--don't leave it unattended. A small
amount of lamp oil gave me the paste consistency I was looking for, but may not
be necessary for your project.
73
Rob
K5UJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|