I have the diagram. I am looking for ideas on if there is an easy way
to hookup the rotor to the controller without having to use a 9 pin
connector. Someone mentioned that there were pin pullers for the
connector. Maybe that is the answer.
On 4/12/2024 6:41 AM, Pete Smith N4ZR wrote:
I'm confused. What are you looking for, Mike - the wiring diagram or
the hardware?
73, Pete N4ZR
On 4/11/2024 9:35 PM, Mike Fatchett W0MU wrote:
I need to check out a T2X rotor with the pigtail and 9 pin connector
assy. I just need to verify that it turns, brakes etc but I would
prefer not to have to use the special connector just for the test
"jig". I wish I had kept the chunk of rotor cable that had the other
end on it now......Would shoulda coulda.
W0MU
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|