In a message dated 25/09/99 20:18:41 EST, frosty@kc1.net writes:
> I have a couple of questions I hope someone can answer, I have some Rohn
> 25G to put up, it is used, and I see that there are two different size
> bolts used to assemble it. One looks like 1/4 inch and one looks like
> 5/16". Can anyone tell me what the correct sizes are?? and how long
> they should be?? Should I use a lock washer ?
The info is in the Rohn catalog but unfortunately I'm out of town and
don't have one. Nonetheless if you need Rohn tower bolts, contact Stan, W7NI,
at w7ni@teleport.com. He has the factory sets for ridiculously low prices.
I would also suggest that you get a copy of the Rohn catalog. It
contains ALL the specs you need that you need to be observing. They are
available from http://www.championradio.com.
>
> It has been suggested that I use 3/16" EHS cable to guy this tower
> with. I want to break the guys up with insulators and have saved some
> previous comments about lengths to use to break up the guys. My
> question is how do I fasten the cable to each insulator? with crosby
> cable clamps? how many each side of the insulator?
Suggested isn't strong enough. 3/16 EHS IS the factory spec.
Hardly anyone uses cable clamps any more since the introduction of
Preformed guy grips but feel free to use them if you want - they're just more
work. You need 3 clamps per termination and be sure to install the saddle on
the 'live' side of the cable. Be sure to use strain insulators designed for
guy wire use.
Cheers & GL, Steve K7LXC
Champion Radio Products
Tower Tech
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|