Hello Bob,
Multiple classes of service:
For the minimalist: battery powered equipment focusing on 12.6 VDC and
solar, photovoltaic, charger
For the average once or twice a year portable operator: Use the mobile
battery and charger.
Start up the engine to charge the battery when voltage goes
below 12.0 VDC
For the few times a year portable operator: Deep discharge batteries
charged by mobile charger , or solar charger
adding more batteries can give you more power or higher voltage
like 2 each 12 V batteries in series for 24 VDC
For the dedicated ROVER operator: a minimum of a 1000W HONDA AC
generator and DC power supplies for required DC voltages
consider the SAMLEX 23 amp, 13.8 VDC switch mode power supply
for a light and compact PS.
consider the HONDA EU1000iA2 generator as advertised in
QSTreet, 629$ http://www.mayberry.com/generators
for a quiet, clean sinewave generator. Consider the
accessories like cover and service and parts manual. Larger quiet units
are available.
With a AC generator you have AC for the antenna rotators, electrical
lights, soda cooler, and the KW power supplies.
Also AC power for the logging laptop computer.
Standardize on DC voltages like 13.8 VDC and/or 28.0 VDC.
Reportedly Pyro Joe's 3.4 GHz 40W bricks will play OK with 13.8 VDC and
lower duty sideband operations, instead of the 12.6 VDC as suggested.
I will advise later on the AVANTEK brick power supply issues.
Stan, WA1ECF
kr7o@vhfdx.com wrote:
> I am looking at incorporating a 10w Avantek 5.7G and one of the 3.4G
> Toshiba amps into my portable microwave station and I am curious as to
> what other people are using for regulated supplies for the odd and in
> some cases fairly critical voltages needed to power these amps. In
> the case of the Avantek, I am talking about the modified units
> requiring +10.5v and -12v, and of course the 12.6v for the Toshiba amps.
>
> For portable operations I typically use two 12v deep cycle batteries
> that will range in voltage between 11.5v and 13v over the course of
> the discharge cycle. -12v shouldn't be a problem, but I haven't found
> zeners or other voltage regulators of the proper voltage and current
> ratings for the other voltages. 12.6v is even more of a challenge
> without some sort of DC-DC converter (but again I haven't found any
> surplus converters that match the needed conditions).
>
> I could always build an AC power supply for the proper voltages, but
> then I need to carry a potentially noisy inverter (and the overhead
> necessary to power that). Resistive voltage dividers are a
> possibility, but still do not provide the level of regulation that
> appears to be needed to protect these devices, and also waste precious
> battery stores.
>
> So, what is everyone using to supply these amps. Hopefully I am
> missing something simple here.
>
>
>
>
> 73, Robert KR7O/YB2ARO, DM07ba/OI52ee (ex. N7STU)
> kr7o@vhfdx.com
>
> www.vhfdx.com (Norcal WSWSS activities & KR7O/YB2ARO homepages)
>
>
>
> _______________________________________________
> Microwave mailing list
> microwave@wa1mba.org
> http://mbs.valinet.com/mailman/listinfo/microwave
>
>
|