Hi, Joe
I was beginning to wonder if this wasn't the case, although several folks
have told me this should work. I guess I've just wasted $30 unless I want to
run RTTY with the clunky RittyRite engine that comes with WriteLog. That
works. (I feel the BPSK interface for WriteLog is just awful, even compared
to the venerable DigiPan.)
Anyway, many thanks. I'm probably going to go with N1MM and see what
happens.
73, Rick, N1RL
-----Original Message-----
From: Joe Subich, W4TV [mailto:lists@microham-usa.com]
Sent: Sunday, March 02, 2008 9:53 PM
To: 'Rick Lindquist'; writelog@contesting.com
Subject: RE: [WriteLog] Using MMTTY with WriteLog
If your USB to serial adapter does not support 5bit codes
at 45.45 baud (e.g., if you must use EXTFSK for MMTTY in
stand alone mode), the MMTTY plug-in will not work.
The MMTTY plug-is does not permit the use of EXTFSK and
WriteLog's "Software generated FSK (TxD)" is only valid for
RTTYrite (the native RTTY support with Sound Board FSK or
Stereo Sound Board FSK).
73,
... Joe, W4TV
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of Rick Lindquist
> Sent: Saturday, March 01, 2008 7:21 PM
> To: writelog@contesting.com
> Subject: [WriteLog] Using MMTTY with WriteLog
>
>
> Well, I'm stumped again. Even after reviewing (and reviewing) the fine
> tutorials by Don, AA5AU, I still cannot get the MMTTY module
> to transmit FSK
> RTTY with WriteLog. MMTTY works fine as a standalone program from its
> currently assigned COM port (7), and I can even get Rittyrite
> to transmit
> FSK (from the type-ahead buffer; there don't appear to be any
> memories -
> just a funky little tuning screen with a very slow response time).
>
>
>
> After selecting the COM 7 under Rittyrite's Ports menu, then "Software
> generated FSK TXD," the "COM-TxD(FSK)" choice in the MMTTY
> Setup MISC screen
> is grayed out. At one point, I got MMTTY/WriteLog to key the
> radio, but it
> just transmitted a carrier, not RTTY.
>
>
>
> I'm using a RIGblaster Plus on COM 7 via a USB - >RS-232
> adapter. The radio
> is an ICOM IC-756PROIII. I had been using the general DXCC
> tracker logging
> module, but it still would not work after I loaded an RTTY
> RoundUp contest
> module.
>
>
>
> Any ideas or suggestions? Many thanks! 73, Rick, N1RL
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|