The syntax is:
CommSlot2=6
Use 2 Ms and it should work.
73, Richard - K5NA
At 14:59 11/26/2008, signup wrote:
>Hi,
>
>Under [Ports] I added the following statements:
>
>ComSlot1=1
>ComSlot2=6
>ComSlot3=7
>ComSlot4=8
>
>The problem is, when I open WriteLog and go to Setup and ports, what
>I see is still Com 1, Com 2, Com 3, and Com 4. Its as I am not
>writing to the correct Writelog.ini; however, I see that the rig
>information for the Yaesu on Com 1 is clearly in the .ini file.
>
>Any suggestions, I have done this in the past and it worked fine, so
>I am confused?
>
>/lee K5UN / TO5X
>
>
>
>
>
>________________________________________________________________
>Sent via the WebMail system at k1nt.com
>
>
>
>
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
>WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|