Hi Rudy,
I do not have a definitive answer relative to WL and RigExpert Combo.
However, I have my CAT Control and demodulator on COM4 and COM5.
Load WRITELOG.INI File, scroll down to [PORTS] and ComSlot3=4 or what every
port RigExpert. But what I read, I think that RigExpert looks for a
VERTUAL PORT.
For my operation, I added the last two lines under {PORTS]:
[Ports]
COM1:=9600,n,8,1,x
COM2:=9600,n,8,1,x
COM3:=9600,n,8,1,x
COM4:=9600,n,8,1,x
CommSlot3=4
CommSlot4=5
When I enable PORTS under WL, I see COM1, COM2, COM4, and COM5.
Gud luck and see ya.
Rick W4UEF
In a message dated 9/9/2006 5:58:25 P.M. Eastern Standard Time,
r_bakalov@yahoo.com writes:
Hello all,
I searched the archive of this list and could not find a complete answer to
my problem. I am trying to make WL work with RE to no avail. One of the
problems is that WL would only work with COM ports 1 thru 4. The second
problem is
that I am not sure which of the 3 ports created by RE should be used for
what purpose. So if anyone is using WL and RE I would very much appreciate the
details of your configuration. I am sure many will benefit from such info.
Interesting enough, the RE group on Yahoo! could not asnwer the same
question either.
Thanks, Rudy N2WQ
_______________________________________________
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|