Thanks Rick,
I see that section, but it is not clear how to set the speed for a port
(COM1 in this case) I am looking for the right syntax to use to set
COM1 to 8n1 9600. Would you or anyone else have a sample of that?
Thanks es 73, John K0TG
Ric Plummer wrote:
> Oops,
> That's the [PORTS] section in the .ini file
> Ric
>
>
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com]On Behalf Of John Desmond
> Sent: Friday, February 09, 2007 00:37
> To: writelog@contesting.com
> Subject: [WriteLog] Packet COM Port Speed Parameter
>
>
> Hi,
>
> In preparing for this weekends WPX, I was working out how to connect
> packet to my laptop. It has a COM1 port, but I am not sure how to set
> the speed on that port in Writelog. The K9JY pages address setting COM
> Port speeds for the Rig Control, but I did not see anything for the
> Packet COM Port.
>
> Does anyone out there have the clip from the INI file that shows a COM
> Port speed setting? What header would it be under too?
>
> Thanks!
>
>
> 73, John K0TG
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|