A couple of weeks ago I put the lines within quotes below on the reflector
but I did not get any ideas from you folks. So I make another try. The
question is: Using the mic connected to the sound board's mic in connector,
do I need to use VOX ON on the rig? I have the impression that Writelog
should key the rig also in this case.
"Hello Users of Writelog,
I have a problem with audio from the microphone in my setup.
I use W98SE, WL v 10.36G.
In Setup/ports I have marked:
COM3 Rig Kenwood (TS-440S) Baud rate Auto Poll checked Comm PTT=Yes
LPT1 CW
DVK type Sound Board (SB Live/7F in test)
All mode PTT on CW Port RTS checked
CW PTT/Command rig on COM port checked
In CW everything is OK, PTT works fine when sending via Fx or ALT-K.
In SSB, PTT works also OK when sending pre-recorded messages via Fx and the
audio is OK. VOX is off.
But when using the mic from the headset nothing happens, PTT doesn't work.
I have understood that it should.
So, what am I missing? Any help would be appreciated."
73 Erik
Erik Hyllander, SM0LZT
e-mail: sm0lzt@svessa.se
alt.: erik.hyllander@telia.com
Packet: SM0LZT@SK0MK
|