Brian,
I have finally gotten my Flex 5000A to work with Writelog and a microHAM
mk2R+ SO2R Controller for casual dxing on two bands.
It is not a contest-grade setup for RTTY with the 5000A because
of internal crosstalk between the two Receivers.
But the Flex 3000 only has 1 receiver doesn't it? So where is the 2nd
VFO? Ah, the transmit VFO. So we are talking in-band use of the two
VFOs?? As in SPLIT mode. I am just guessing since my Flex is the 5000.
You might take a look at the Elcraft K3 rig driver. It is very close to
what you might want for in-band (run and multiplier setup) and allows
two radios to be set up on the same port for CAT.
I have much information on my trials. I can get back to you after the
WPX if you need.
Jerry, W6IHG
On 2/7/2013 9:42 PM, Brian Miller wrote:
Hi all
I'm exploring the feasibility of using WriteLog with PowerSDR and a
FlexRadio 3000 transceiver. I have successfully connected Writelog with
the radio using the Kenwood TS2000 CAT protocol. However, I don't seem
to be able to configure the logging software to operate in SO2V mode. I
can pull up the two band maps but there does appear to be any way of
bringing up a second entry window (similar to what would be used in SO2R
mode).
Is it possible to configure WriteLog to operate a FlexRadio transceivers
in SO2V mode? If so then any advice on how to achieve this would be
much appreciated.
Thanks and 73
Brian VK3MI ZL1AZE
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
--
-----------------------------------------------
Dr. Jerry R. Pixton, PIXOS Designs
http://www.shentel.net/pixosdesigns/RadioTuner/
jpixton@shentel.net
-----------------------------------------------
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|