- Also I notice that Writelog/2Tone remembers only the last decode
> setting, not the decode setting for each clone window.
Use a separate directory for each window. The decode setting, input
channel, port (if using FSK), are all stored in 2tone.ini (one per
directory).
73,
... Joe, W4TV
On 2014-07-19 1:33 PM, Jeff Stai wrote:
I keep forgetting to put these out there to see if there is a solution.
I've just been taking care to verify settings to get around them, so I
would call them nits:
- When I open a clone window from a MMTTY main window, I want the clone TX
port to be set to NONE, which I do. This setting is not remembered the next
time I open this window - I have to go in to Setup and flip it to NONE.
- When using 2Tone in a SO2V situation, the Right/Left setting for the
sound card does not get remembered the next time I open the 2Tone windows.
It just remembers the last one set the last time I opened 2Tone clone
windows. For example, if I open two 2Tone clones on the left channel and
then one on the right channel, the next time I run Writelog and open a
2Tone clone on the left it comes up on the right (wrong ;) channel.
- Also I notice that Writelog/2Tone remembers only the last decode setting,
not the decode setting for each clone window.
No big deal, just need to be extra careful. 73 and have fun! jeff wk6i
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|