For those who do not also subscribe to the Microham reflector please see the
message below that I sent to Microham Tech Support and the Microham user
reflector earlier this evening.
PROBLEM SOLVED!!! Once again cockpit error on my part. This is getting
monotonous.
When I set up router for the 7600 I went to the Ports tab and Set the hex
address for the 7800 driver to be 7A, the default for the 7600. What I
forgot was the System Settings tab also has a hex address setting for the
CI-V port setting. The next to the last instruction in Jozef's note finally
set off an alarm in my dim bulb mind. Sure enough the Settings Tab was set
to 6A from the 7800 driver. As soon as I changed this to 7A the 7600, the
PW-1 and the MKII are happily talking to each other again! When will I ever
learn???
Thanks so much Jozef and Joe for the help and aploogies to the reflector for
consuming so much bandwidth with what turned out to be "my bad"!
73,
Gary AL9A
----- Original Message -----
From: "Gary AL9A" <al9a@mtaonline.net>
To: "Writelog Reflector" <writelog@contesting.com>
Sent: December 29, 2009 10:39 PM
Subject: Re: [WriteLog] WriteLog Digest, Vol 84, Issue 18
Still can't get the PW-1 to recognize band changes so the challenge
continues.
73,
Gary AL9A
----- Original Message -----
From: "Ron NØAT" <n0at@comcast.net>
To: "'Gary AL9A'" <al9a@mtaonline.net>
Sent: December 29, 2009 9:01 AM
Subject: RE: [WriteLog] WriteLog Digest, Vol 84, Issue 18
Gary,
I use the IC-7800 driver for my IC-7600. I can type in a frequency and the
radio goes there. It also works when typing in a split frequency.
73 de Ron NØAT
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|