Understood, but in the Writelog port setup, you cannot duplicate a port. So,
lets say you have radio one in the 1st window set to COM port 1, (where the
CT-17 is connected to) and radio two in the 2nd window, you cannot name it
COM port 1 again. Writelog will not allow it.
So, how do you route the CIV from the other radios connected to the CT-17 on
COM1 to the other radios?
Andre
NJ0F
--------------------------------------------------
From: "Len Morris" <lmorris@lenmar.net>
Sent: Thursday, March 22, 2012 2:04 PM
To: "Andre VanWyk" <kr5dx@yahoo.com>
Cc: <writelog@contesting.com>
Subject: Re: [WriteLog] Icom CT-17 with Writelog
> Each Icom radio has its own Hex address, and the CT-17 connects to one
> com port.
> Len
>
> On 2012-03-22, at 2:53 PM, Andre VanWyk wrote:
>
>> Does anyone out there know of a way to use an Icom CT-17 CIV unit (with
>> multiple radios connected to it) with Writelog.
>> Since there is no way to be able to assign the same com port number to
>> both radios, I would guess this is impossible, but there might be some
>> virtual comport / bridging software out there?
>> Any help would be appreciated.
>>
>> 73
>> Andre NJ0F
>> _______________________________________________
>> WriteLog mailing list
>> WriteLog@contesting.com
>> http://lists.contesting.com/mailman/listinfo/writelog
>> WriteLog on the web: http://www.writelog.com/
>
> Len Morris VA3LM/VE3FJB
> lenmorris@lenmar.net
>
>
>
>
>
>
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|