I'm sure there is a simple answer, but I haven't been able to figure this
one out.
I'm using a PC running Windows XP, and have a RigBlaster Pro going to my
Icom IC-706MKIIG.
If I use MixW, or MMITTY as stand alone programs with the RigBlaster Pro, I
am able to receive and transmit without any trouble. However, if I close
everything down, and then bring up WriteLog, the minute I load WriteLog, it
puts the RigBlaster Pro into the transmit mode and won't get out of
transmit. There must be a setting that I need to change, but I have not been
able to find it. No matter what I set Ports configuration to, RigBlaster
always goes into transmit. However the problem does not happen on the other
programs.
Any thoughts?
Thanks,
Ross
K6GFJ
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|