I view this as a trivial software design. You have the
two radios on different addresses and both are set to
transceive. When you swap radios, you swap addresses you
control but you could still listen to both at all times
since they are on the same wire. When in transceive,
they only announce when moved. You could also turn trans
ceive off since there would be collisions as there is no
"carrier sense" or flow control and interrogations would
have to be done but I see this as no programming problem
at all. It is a matter of the extra complexity being worth
it to Wayne to do.
Bob
N4HY
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com]On Behalf Of Steve Baron - KB3MM
Sent: Wednesday, September 24, 2003 2:37 AM
To: ka9cfd@winco.net; Writelog@contesting.com
Subject: Re: [WriteLog] Two Icom Radios on the Same Com Port
I would think it is a potentially very complicated topic.
----- Original Message -----
From: "Jay Hainline" <ka9cfd@winco.net>
To: <Writelog@contesting.com>
Sent: Tuesday, September 23, 2003 20:37
Subject: RE: [WriteLog] Two Icom Radios on the Same Com Port
> Hmm, I would think there would be enough Icom radio users out there to
> justify writing software to support this. My 2 cents worth.
>
> 73 Jay
>
> Jay Hainline KA9CFD EN40om
> Colchester, IL
> ka9cfd@arrl.net
> http://www.qsl.net/learc
>
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of llindblom@juno.com
> Sent: Tuesday, September 23, 2003 13:48
> To: ricp@alum.wpi.edu
> Cc: w5pr@swbell.net; Writelog@contesting.com
> Subject: Re: [WriteLog] Two Icom Radios on the Same Com Port
>
>
>
> Ric is 100% correct. I believe W5XD stated several years back this was a
> very low priority upgrade to WriteLog as it will only impact a small
number
> of users. Wayne, correct me if I misstated this.
>
> 73 W0ETC (who has two ICOM rigs)
>
> -- "Ric Plummer" <ricp@charter.net> wrote:
> Chuck
> I believe WL doesn't support that construct at the present time. I know
> Logic6 does, so it can be done. Ric KV1W
>
>
> ----- Original Message -----
> From: "Chuck" <w5pr@swbell.net>
> To: "'WriteLog'" <Writelog@contesting.com>
> Sent: Tuesday, September 23, 2003 03:52
> Subject: [WriteLog] Two Icom Radios on the Same Com Port
>
>
> > I am fairly new to Writelog. Is there an archive about using WL with
> > two Icom radios with one CT-17 on a single serial port?
> >
> > Chuck W5PR
> >
> >
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
> > WriteLog on the web: http://www.writelog.com/
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|