And the section may not be in the writelog.ini file. If that is the case,
you can add. Just cut and paste the entire text from Don's e-mail into your
writelog.ini file, save the file then restart writelog. Then the cut
numbers should work.
Good luck.
73 de Al, KE1FO
-----
Check out my Amateur Radio Contesting blog at ke1fo.wordpress.com.
On Wed, Sep 23, 2009 at 7:46 AM, Edward Taylor <Phinehas@columbus.rr.com>wrote:
> Hello to all,
>
> I sent a email about a week ago asking about the CW display. Gary, AL9A,
> was kind enough to provide an answer. Thanks Gary!
>
> My new problem is this: when I set up the CW/RTTY/SSB Memory Setup window,
> I type in %3 so that my sequence will be sent in a three digit format. The
> instructions in the WriteLog Manuals say that "T" will be sent for "0"
> (zero). However, my program sends "0" NOT "T" This makes a big difference
> in CW contesting.
>
> The manual states that "if the mode is CW, the digits are translated to
> letters according to the [Cut-Numbers] section in WRITELOG.INI." When I go
> to the [Cut-Number] instructions of the manual, it shows a table that says
> that 0 will be sent as 0 if "you don't set up this section." The manual
> states that the WriteLog.ini file is in ASCII and is "directly editable."
>
> I have not been able to discover how to set up the [Cut-Number] section of
> the WriteLog.ini file to send T for zero. I haven't even been able to find
> the [Cut-Number] section in the .ini file.
>
> Help? Anyone!
>
> 73,
> Ed WB8TSD
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|