Kjell - Thanks.
These numbers are what I'm seeing. My radio was originally a V1.2, and
several years ago I sent it to Yaesu for some repairs, and had the ROM
upgraded to 1.3. I wrote the program from the values in my manual. A couple
of days ago I did a reset to see if it would cure another problem, and the
mode codes changed then, I think. It's like it woke up the 1.3 ROM. Makes no
sense to me, and it didn't cure my other problem. I'll note your values in
my manual, and thanks for sending them.
Now if I could just find out where my ALC went.......
73, Mike NF4L
----- Original Message -----
From: "Kjell W. Strom" <strom@lime.demon.nl>
To: <nf4l@nf4l.com>; "Yaesu reflector" <Yaesu@contesting.com>
Sent: Thursday, August 07, 2003 6:30 AM
Subject: RE: [Yaesu] FT-990 CAT
> Mike,
>
> My FT-990 was shipped with v. 1.3 and according to the manual the
following
> codes are used for setting the mode:
>
> LSB 0
> USB 1
> CW 2.4 kHz 2
> CW 500 Hz 3
> AM 6 kHz 4
> AM 2.4 kHz 5
> FM 6 or 7
> RTTY LSB 8
> RTTY USB 9
> Packet LSB A
> Packet FM B
>
> The returned mode data from the radio should be in the range 0-6. The
> filter bandwidth can still be set separately with opcode 8C.
>
> I have not checked if the manual is correct. I have not been writing CAT
> software since the FT-757GX and -767...
>
> 73,
> "Kel"
> PB3SM - SM6CPI
>
>
>
>
>
>
|