Hi Roger,
Band Data 2 (which plugs into the FTDX-5000 TX REQ jack) is required for the
F SET and TUNE functions, which both operate by keying the exciter. If the
Quadra is not tracking the band selection on the FTDX-5000, there may be a
common/ground return issue.
I use my Quadra with two Icom exciters. Band Data 2 is connected to ACC2
Pins 2/3. Band Data 1 is not used. PTT and ALC are connected via a stereo
RCA-ended cable.
73, Adam VA7OJ/AB4OJ
-----Original Message-----
From: Yaesu [mailto:yaesu-bounces@contesting.com] On Behalf Of Roger (K8RI)
Sent: 16-Aug-13 23:00
Cc: yaesu@contesting.com
Subject: Re: [Yaesu] Quadra
On 8/17/2013 1:30 AM, Adam Farson wrote:
> Hi Roger,
>
> Do you have the Band Data 1, Band Data 2 (Control) and ALC cables
> connected
I'm not using the band data 2 for the auto tune, but otherwise as far as I
can see it should work.
which is listed as not needed except for that function.
I do need to check the grounding, but the auto band switching should work
just by changing bands.
I had a Tokyo Hy Power 1.5 KFX and the band switching was flawless.
73
Roger (K8RI)
> per page 13 of the FTDX-5000 user manual? Band tracking, F SET and
> TUNE should all work if all the required interconnecting cables are in
place.
>
> 73, Adam VA7OJ/AB4OJ
>
> -----Original Message-----
> From: Yaesu [mailto:yaesu-bounces@contesting.com] On Behalf Of Roger
> (K8RI)
> Sent: 16-Aug-13 19:17
> To: yaesu@contesting.com
> Subject: [Yaesu] Quadra
>
> I picked up a quadra and an FT1000 MK-V. I wanted the Quadra to go
> with my 5000MP and the 1000 as a back up.
>
> So far I think I have the proper cable in the proper places and menu
> 172 enabled on the 5000MP.
>
> When I turn on the 5000MP the Quadra powers up and goes through the
> self check and gives me Protection ON, Voltage NORMAL, Bias Check,
> Temp Normal, Maintenance Mode ON, Slave ON.
>
> My problem is I can't get the Quadra to change bands. It stays on 50
> MHz. I can set it to manual, press F-Set and key the exciter (with
> low
> power) It goes through its cycle, but the band still doesn't change.
>
> Any thoughts?
>
> I'm a complete novice where the Quadra is concerned and am sticking
> strictly to the procedures in the manual.
>
> 73
>
> Roger (K8RI)
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
>
>
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|