Thanks Tom, I've been needing one of those. The connector body is very
low-melting point plastic rather than phenolic so you have to be very careful
when soldering to the pins or you'll end up with loose pins like I did.
73,
-Dick-
N3XRU
-----Original Message-----
From: Yaesu [mailto:yaesu-bounces@contesting.com] On Behalf Of Tom-W3FRG
Sent: Saturday, January 28, 2017 08:14
To: yaesu@contesting.com
Subject: [Yaesu] Yaesu large 6 pin rotor connector
If your Yaesu rotor controller uses the old, large Cinch type, 6 pin connector
with pin #1 rotated 90° check this out.
Look up eBay : Item # 252698972053
GL Tom W3FRG
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|