Do you happen to know the Part # of this trimmer ? Where is is on the Local
board ?
I have the service Manul as a referance.
Thanks
At 02:57 PM 6/21/2003 -0300, GGLL wrote:
> Check first the trimmer capacitor which adjusts reference crystal
>oscillator (Local unit), it may be dirty, rotate it back and forth
>several times, if it stabilizes then you can use it a few more time, if
>not you must change it. After this you must also re-calibrate your
>frequency display.
>
>Good luck
>Guillermo - LU8EYW.
>
>David Vondrasek escribi?::
>
>>By 757 has all of a sudden started drifting down about 1.5 kcs. Then after
>>a while jump back on freq. It's not a slow drift it just jumps down. I can
>>turn the dial and get back to the station and after a while it goes back to
>>where it belongs. I don't think it's heat related as it does it 3-5
>>minutes after I've turned it on. Anyone seen this ? Have an idea what the
>>deal is ? I notice the TX is a little wrong also while it's drifted. I
>>can't get full power. Once it gioes back I have a full 100 watts again.
>>
>>_______________________________________________
>>Yaesu mailing list
>>Yaesu@contesting.com
>>http://lists.contesting.com/mailman/listinfo/yaesu
>>
>>
>>
>
>_______________________________________________
>Yaesu mailing list
>Yaesu@contesting.com
>http://lists.contesting.com/mailman/listinfo/yaesu
>
|