Hi Sam, yes into a good dummy load is where the reading are from, and
when switching to the FT1000D I see 210-220 watts? I am not sure, but
Yaesu may just want everyone to think they have more power out because
the meter on the Mark-V says 200 watts? Just question if anyone else
realy measured the output?
Thanks, Bob W8GC
Sam_Stimson@Dell.com wrote:
>
> Have you put a good 50 ohm load on the Mark-V and measured the power into
> that? That would be the first place I would start. If you are not getting
> the full power out into a 50 ohm load, then you might have a problem.
>
> Sam
> N5WU
--
FAQ on WWW: http://www.contesting.com/FAQ/yaesu
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
|